Specify A Default Gateway; Enable Dhcp Server - Dell Force10 S4810P Configuration Manual

Specify an Address Lease Time
Task
Specify an address lease time for the addresses in a pool.

Specify a Default Gateway

The IP address of the default router should be on the same subnet as the client.
Task
Specify default gateway(s) for the clients on the subnet, in
order of preference.

Enable DHCP Server

This feature is available on
The DHCP server is disabled by default.
Step Task
1 Enter the DHCP command-line context.
2 Enable DHCP server.
3 Display the current DHCP configuration.
In the illustration below, an IP phone is powered by PoE and has acquired an IP address from the Dell
Force10 system, which is advertising LLDP-MED. The leased IP address is displayed using
, and confirmed with
binding
Command Syntax
lease
infinite
Default: 24 hours
c s
and (S25/S50) platforms only.
Command Syntax
ip dhcp server
no disable
Default: Disabled
show config
.
show lldp neighbors
Relay Agent
{ [ ] [
days hours minutes
}
Command Syntax
default-router address
Command Mode
CONFIGURATION
DHCP
DHCP
7/1
Dynamic Host Configuration Protocol (DHCP) | 383
Command Mode
] | DHCP <POOL>
Command Mode
DHCP <POOL>
show ip dhcp
DNS Server