Apply A Privilege Level To A Username; Apply A Privilege Level To A Terminal Line - Dell Force10 S4810P Configuration Manual

end
exit
interface
line
linecard
FTOS(conf)#interface ?
fastethernet
gigabitethernet
loopback
managementethernet
null
port-channel
range
sonet
tengigabitethernet
vlan
FTOS(conf)#interface gigabitethernet 1/1
FTOS(conf-if-gi-1/1)#?
end
exit
FTOS(conf-if-gi-1/1)#exit
FTOS(conf)#line ?
aux
console
vty
FTOS(conf)#line vty 0
FTOS(config-line-vty)#?
exit
FTOS(config-line-vty)#

Apply a Privilege Level to a Username

To set a privilege level for a user:
Task
Configure a privilege level for a user.

Apply a Privilege Level to a Terminal Line

To set a privilege level for a terminal line:
Task
Configure a privilege level for a terminal line.
56
| Management
Exit from configuration mode
Exit from configuration mode
Select an interface to configure
Configure a terminal line
Set line card type
Fast Ethernet interface
Gigabit Ethernet interface
Loopback interface
Management Ethernet interface
Null interface
Port-channel interface
Configure interface range
SONET interface
TenGigabit Ethernet interface
VLAN interface
Exit from configuration mode
Exit from interface configuration mode
Auxiliary line
Primary terminal line
Virtual terminal
Exit from line configuration mode
Command Syntax
username username privilege level
Command Syntax
privilege level
Command Mode
CONFIGURATION
Command Mode
LINE
level