Station Move Violation Actions; Recovering From Learning Limit And Station Move Violations - Dell Force10 S4810P Configuration Manual

Station Move Violation Actions

Station Move Violation Actions are supported only on platforms: S-Series (S25/S50)
no-station-move
occurs using one the following options with the
Task
Generate a system log message
indicating a station move.
Shut down the first port to learn the
MAC address.
Shut down the second port to learn the
MAC address.
Shut down both the first and second port
to learn the MAC address.
To display a list of interfaces configured with MAC learning limit or station move violation actions:
Task
Display a list of all of the interfaces
configured with MAC learning limit or
station move violation.

Recovering from Learning Limit and Station Move Violations

After a learning-limit or station-move violation shuts down an interface, you must manually reset it:
Task
Reset interfaces in ERR_Disabled state caused
by a learning limit violation or station move
violation.
Reset interfaces in ERR_Disabled state caused
by a learning limit violation.
Reset interfaces in ERR_Disabled state caused
by a station move violation.
Note: Alternatively, you can reset the interface by shutting it down using the
reenabling it using the command
626
| Layer 2
is the default behavior. You can configure the system to take an action if a station move
Command Syntax
station-move-violation log
station-move-violation shutdown-original
station-move-violation shutdown-offending
station-move-violation shutdown-both
Command Syntax
show mac learning-limit violate-action
Command Syntax
mac learning-limit reset
mac learning-limit reset learn-limit-violation
[interface | all]
mac learning-limit reset
station-move-violation [interface | all]
no shutdown
command:.
mac learning-limit
.
Command Mode
INTERFACE
INTERFACE
INTERFACE
INTERFACE
Command Mode
CONFIGURATION
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
shutdown command and then