Configure static ARP entries
ARP dynamically maps the MAC and IP addresses, and while most network host support dynamic
mapping, you can configure an ARP entry (called a static ARP) for the ARP cache.
To configure a static ARP entry, use the following command in the CONFIGURATION mode:
Command Syntax
arp ip-address mac-address interface
These entries do not age and can only be removed manually. To remove a static ARP entry, use the
ip-address
To view the static entries in the ARP cache, use the
as shown below.
FTOS#show arp
Protocol
--------------------------------------------------------------------------------
Internet
FTOS#
Enable Proxy ARP
By default, Proxy ARP is enabled. To disable Proxy ARP, use
mode.
To re-enable Proxy ARP, use the following command in the INTERFACE mode:
Command Syntax
ip proxy-arp
To view if Proxy ARP is enabled on the interface, use the
mode. If it is not listed in the
displayed in the
526
|
IPv4 Routing
Command Mode
CONFIGURATION
command syntax.
Address
Age(min)
10.1.2.4
show config
command output.
show config
Purpose
Configure an IP address and MAC address mapping
for an interface.
•
ip-address:
(A.B.C.D).
•
mac-address:
format
•
interface:
information.
show arp static
Hardware Address
17
08:00:20:b7:bd:32
no proxy-arp
Command Mode
INTERFACE
show config
command output, it is enabled. Only nondefault information is
IP address in dotted decimal format
MAC address in nnnn.nnnn.nnnn
enter the interface type slot/port
command in the EXEC privilege mode
Interface
VLAN
Ma 1/0
-
command in the interface
Purpose
Re-enable Proxy ARP.
command in the INTERFACE
no arp
CPU
CP