Configure Static Routes For The Management Interface - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

To view the configured routes, use the

FTOS#show ip route static

FTOS installs a next hop that is on the directly connected subnet of current IP address on the interface (for

example, if interface gig 0/0 is on 172.31.5.0 subnet, FTOS installs the static route).

FTOS also installs a next hop that is not on the directly connected subnet but which recursively resolves to

a next hop on the interface's configured subnet. For example, if gig 0/0 has ip address on subnet 2.2.2.0 and

if 172.31.5.43 recursively resolves to 2.2.2.0, FTOS installs the static route.

When interface goes down, FTOS withdraws the route.

When interface comes up, FTOS re-installs the route.

When recursive resolution is "broken," FTOS withdraws the route.

When recursive resolution is satisfied, FTOS re-installs the route.

Configure static routes for the management interface

When an IP address used by a protocol and a static management route exists for the same prefix, the

protocol route takes precedence over the static management route.

To configure a static route for the management port, use the following command in the

CONFIGURATION mode:

show ip route static

Direct, Nu 0

via 6.1.20.2, Te 5/0

Direct, Nu 0

Direct, Lo 0

Dist/Metric Last Change

----------- -----------

IPv4 Routing | 521