Dell Force10 S4810P Configuration Manual page 848

Command Syntax
redistribute ospf
match internal ] [ metric
]
map-name
To view the current RIP configuration, use the
show config
Set send and receive version
To specify the RIP version, use the
receive only one or the other version, use the
the INTERFACE mode.
To change the RIP version globally in FTOS, use the following command in the ROUTER RIP mode:
Command Syntax
version { 1 | 2 }
You can set one RIP version globally on the
the interfaces participating in RIP unless the interface was specifically configured for a specific RIP
version.
Use the
show config
configured. You can also use the
protocols configuration.
Figure 40-3
set to RIPv2. When the ROUTER RIP mode
participating in the RIP process is also set to send and receive RIPv2.
848
| Routing Information Protocol (RIP)
[ match external { 1 | 2 } |
process-id
] [ route-map
value
command in the ROUTER RIP mode.
command in the ROUTER RIP mode to see whether the
show ip protocols
shows an example of the RIP configuration after the ROUTER RIP mode
Command Mode
ROUTER RIP
show running-config
command in the ROUTER RIP mode. To set an interface to
version
ip rip send version
Command Mode Purpose
ROUTER RIP Set the RIP version sent and received on the system.
. This command sets the RIP version for RIP traffic on
system
command in the EXEC mode to view the routing
command is set, the interface (GigabitEthernet 0/0)
version
Purpose
Include specific OSPF routes in RIP.
Configure the following parameters:
• range: 1 to 65535
process-id
• range: 0 to 16
metric
• : name of a configured route
map-name
map.
command in the EXEC mode or the
or the
ip rip receive version
command is
version
version
commands in
command is