Dell Force10 S4810P Configuration Manual page 591

Redistribute routes
In addition to filtering routes, you can add routes from other routing instances or protocols to the IS-IS
process. With the
connected routes in the IS-IS process.
Note: Do not route iBGP routes to IS-IS unless there are route-maps associated with the IS-IS
redistribution.
IPv4 routes
Use any of the following commands in ROUTER ISIS mode to add routes from other routing instances or
protocols.
Note: These commands apply to IPv4 IS-IS only . Use the ADDRESS-FAMILY IPV6 mode shown later to
apply prefix lists to IPv6 routes.
Command Syntax
{
redistribute bgp as-number
} [
static level-1 level-1-2
] [
metric-type
metric-value
[ ]
route-map map-name
r
edistribute ospf process-id
]
[ ] [
level-2 metric value match external {1 | 2}
[ {
internal] metric-type external | internal
[ ]
route-map map-name
command syntax, you can include BGP, OSPF, RIP, static, or directly
redistribute
| | |
connected rip
| ] [
level-2 metric
{ }]
external | internal
[ |
level-1| level-1-2
|
match
}]
Command Mode Purpose
ROUTER ISIS Include BGP, directly connected, RIP, or
user-configured (static) routes in IS-IS.
Configure the following parameters:
•
level-1
all redistributed routes to a level.
Default is
•
metric
0.
•
metric-type
internal.
•
map-name
map.
ROUTER ISIS Include specific OSPF routes in IS-IS.
Configure the following parameters:
•
process-id
•
level-1
all redistributed routes to a level.
Default is
•
metric
0.
•
match external
• match internal
•
metric-type:
•
map-name
map.
Intermediate System to Intermediate System | 591
, , or : Assign
level-1-2 level-2
.
level-2
range: 0 to 16777215. Default is
: choose either
external
Default is internal.
: name of a configured route
range: 1 to 65535
, , or :: Assign
level-1-2 level-2
.
level-2
range: 0 to 16777215. Default is
range: 1 or 2
external or internal.
: name of a configured route
or