Advertising Tlvs - Dell Force10 S4810P Configuration Manual

Advertising TLVs

You can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.
• If you configure the system globally, all interfaces will send LLDPDUs with the specified TLVs.
• If you configure an interface, only the interface will send LLDPDUs with the specified TLVs.
If LLDP is configured both globally and at interface level, the interface level configuration overrides the
global configuration. To advertise TLVs:
Step Task
1 Enter LLDP mode.
2 Advertise one or more TLVs. Include the keyword for
each TLV you want to advertise.
•
For 802.1 TLVs:
vlan-name
•
•
Note:
In Figure
management, 802.1, and 802.3 TLVs.
652
| Link Layer Discovery Protocol (LLDP)
For management TLVs:
system-capabilities,
system-description
port-protocol-vlan-id, port-vlan-id,
For 802.3 TLVs:
max-frame-size
For TIA-1057 TLVs:
• guest-voice
• guest-voice-signaling
• location-identification
• power-via-mdi
• softphone-voice
• streaming-video
• video-conferencing
• video-signaling
• voice
• voice-signaling
The vlan-name command is supported on C-Series and S-Series only.
30-8, LLDP is enabled globally. R1 and R2 are transmitting periodic LLDPDUs that contain
Command
protocol lldp
advertise {management-tlv |
dot1-tlv | dot3-tlv | med}
Command
Mode
CONFIGURATI
ON or
INTERFACE
PROTOCOL
LLDP