Dell Force10 S4810P Configuration Manual page 887

Figure 43-2. Configuring a Custom Privilege Level
FTOS(conf)#username john privilege 8 password john
FTOS(conf)#enable password level 8 notjohn
FTOS(conf)#privilege exec level 8 configure
FTOS(conf)#privilege config level 8 snmp-server
FTOS(conf)#end
FTOS#show running-config
Current Configuration ...
!
hostname Force10
!
enable password level 8 notjohn
enable password Force10
!
username admin password 0 admin
username john password 0 john privilege 8
!
Figure 43-3 is a screen shot of the Telnet session for user "john". The
confirms that "john" is in privilege level 8. In the EXEC Privilege mode, "john" can access only the
commands listed. In CONFIGURATION mode, "john" can access only the
Figure 43-3. User john's Login and the List of Available Commands
apollo% telnet 172.31.1.53
Trying 172.31.1.53...
Connected to 172.31.1.53.
Escape character is '^]'.
Login: john
Password:
FTOS#show priv
Current privilege level is 8
FTOS#?
configure
disable
enable
exit
no
show
terminal
traceroute
FTOS#confi
FTOS(conf)#?
end
exit
no
snmp-server
FTOS(conf)#
Specify LINE mode password and privilege
You can specify a password authentication of all users on different terminal lines. The user's privilege
level will be the same as the privilege level assigned to the terminal line, unless a more specific privilege
level is is assigned to the user.
Configuring from terminal
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Negate a command
Show running system information
Set terminal line parameters
Trace route to destination
Exit from Configuration mode
Exit from Configuration mode
Reset a command
Modify SNMP parameters
The user john is assigned privilege level
8 and assigned a password.
All other users are assigned a password
to access privilege level 8
The command configure is assigned to
privilege level 8 since it is needed to
reach the CONFIGURATION mode
where the snmp-server commands are
located.
The snmp-server commands, in the
CONFIGURATION mode, are assigned
to privilege level 8.
command output
show privilege
commands.
snmp-server
Security | 887