Dell Force10 S4810P Configuration Manual page 335

Figure 13-10. show interfaces pfc summary Command Example
FTOS# show interfaces
Interface TenGigabitEthernet 0/49
Admin mode is on
Admin is enabled
Remote is enabled, Priority list is 4
Remote Willing Status is enabled
Local is enabled
Oper status is Recommended
PFC DCBx Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 45556 pause quantams
Application Priority TLV
--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
FTOS# show interfaces tengigabitethernet 0/49 pfc detail
Interface TenGigabitEthernet 0/49
Admin mode is on
Admin is enabled
Remote is enabled
Remote Willing Status is enabled
Local is enabled
Oper status is recommended
PFC DCBx Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 45556 pause quanta
Application Priority TLV
--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts, 0 Pause Tx pkts, 0 Pause Rx pkts
Table 13-3. show interface pfc summary Command Description
Field
Interface
Admin mode is on
Admin is enabled
tengigabitethernet 0/49 pfc
Parameters :
Parameters :
Interface type with stack-unit and port number.
PFC Admin mode is on or off with a list of the configured PFC priorities.
When PFC admin mode is on, PFC advertisements are enabled to be sent and
received from peers; received PFC configuration takes effect.
The admin operational status for a DCBx exchange of PFC configuration is
enabled or disabled.
summary
Description
Data Center Bridging (DCB) | 335