Displaying Iscsi Optimization Information - Dell Force10 S4810P Configuration Manual

Step Task
9 (Optional) Enter interface configuration mode to
configure the auto-detection of Compellent disk
arrays.
10 (Optional) Configures the auto-detection of
Compellent arrays on a port.
Default: Compellent disk arrays are not detected.

Displaying iSCSI Optimization Information

Use the commands in
show
Table 26-2. Displaying iSCSI Optimization Information
Command
(Figure 26-2)
show iscsi
(Figure
show iscsi sessions
show iscsi sessions detailed
(Figure 26-4)
show run iscsi
Figure 26-2. show iscsi Command Example
FTOS#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
Table 26-2 to display information on iSCSI optimization
Output
Displays the currently configured iSCSI settings.
26-3) Displays information on active iSCSI sessions on the switch.
[ ] Displays detailed information on active iSCSI sessions on the switch. To
session isid
display detailed information on specified iSCSi session, enter the session's
iSCSi ID.
Displays all globally-configured non-default iSCSI settings in the current
FTOS session.
Command
/
interface port-type slot
port
[no] iscsi profile-compellent
Command Mode
CONFIGURATION
INTERFACE
iSCSI Optimization | 569