Clearing A Ufd-Disabled Interface - Dell Force10 S4810P Configuration Manual

Step Command Syntax and Mode
5 description text
Command Mode:
UPLINK-STATE-GROUP
6
no enable
Command Mode:
UPLINK-STATE-GROUP

Clearing a UFD-Disabled Interface

You can manually bring up a downstream interface in an uplink-state group that has been disabled by UFD
and is in a UFD-disabled error state. To re-enable one or more disabled downstream interfaces and clear
the UFD-disabled error state, enter the following command:
Command Syntax
clear ufd-disable
uplink-state-group group-id
Command Mode: EXEC
1044
| Uplink Failure Detection (UFD)
{
interface interface |
}
Description
(Optional) Enters a text description of the uplink-state group.
Maximum length: 80 alphanumeric characters.
(Optional) Disables upstream-link tracking without deleting the
uplink-state group.
Default: Upstream-link tracking is automatically enabled in an
uplink-state group.
To re-enable upstream-link tracking, enter the enable command.
Description
Re-enables a downstream interface on the switch/router that is in a
UFD-disabled error state so that it can send and receive traffic.
For , enter one of the following interface types:
interface
Fast Ethernet: fastethernet {
1-Gigabit Ethernet: gigabitethernet {
10-Gigabit Ethernet:
tengigabitethernet {
slot/port
Port channel: port-channel {1-512 |
Where and
port-range port-channel-range
separated by a dash (-) and/or individual ports/port channels in any
order; for example:
gigabitethernet 1/1-2,5,9,11-12
port-channel 1-3,5
A comma is required to separate each port and port-range entry.
{
clear ufd-disable interface interface
re-enables all UFD-disabled downstream interfaces in the group.
Range: 1 to 16.
| }
slot/port slot/port-range
|
slot/port slot/port-range
| }
slot/port-range
}
port-channel-range
e specify a range of ports
| uplink-state-group group-id
}
}