Vlan Interface Counters - Dell Force10 S4810P Configuration Manual

Assign an IP address to a VLAN
VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, you must
assign an IP address to the VLANs to route traffic between the two interfaces.
The
shutdown
shutdown
Note: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To assign
another VLAN ID to the Default VLAN, use the
To assign an IP address, use the following command in INTERFACE mode:
Command Syntax
ip address
ip-address mask
In FTOS, VLANs and other logical interfaces can be placed in Layer 3 mode to receive and send routed
traffic. For details, see

VLAN Interface Counters

VLAN counters can be enabled for either Ingress packets, egress packets, or both. VLAN counters are
disabled by default, and are supported on E-Series ExaScale
Command Syntax
enable vlan-counter [ingress | egress |
all]
To return to the default without any VLAN counters, enter no
Note: VLAN output counters may show higher than expected values because source-suppression drops
are counted.
1060
| Virtual LANs (VLAN)
command in INTERFACE mode does not affect Layer 2 traffic on the interface; the
command only prevents Layer 3 traffic from traversing over the interface.
[ secondary ]
Bulk Configuration
Command Mode
CONFIGURATION
default vlan-id vlan-id
Command Mode Purpose
INTERFACE Configure an IP address and mask on the interface.
•
ip-address mask
dotted-decimal format (A.B.C.D) and the mask
must be in slash format (/24).
• secondary — This is the interface's backup IP
address. You can configure up to eight secondary
IP addresses.
.
e
Purpose
Configure ingress, egress or both counters for VLAN
interfaces.
command.
— Enter an address in
x only.
enable vlan-counter .