Implementing Ipv6 With Ftos - Dell Force10 S4810P Configuration Manual

case, a DHCP server is used, but it is specifically configured to always assign the same IPv6 address to a
particular computer, and never to assign that IP address to another computer. This allows static IPv6
addresses to be configured in one place, without having to specifically configure each computer on the
network in a different way.
In IPv6, every interface, whether using static or dynamic address assignments, also receives a local-link
address automatically in the fe80::/64 subnet.

Implementing IPv6 with FTOS

FTOS supports both IPv4 and IPv6 and both may be used simultaneously in your system.
Note: Dell Force10 recommends that you use FTOS version 7.6.1.0 or later when implementing
IPv6 functionality on an E-Series system.
Table 25-2
sections following the table give some greater detail about the feature. Specific platform support for each
feature or functionality is designated by the following symbols:
Table 25-2. FTOS and IPv6 Feature Support
Feature and/or
Functionality
Basic IPv6
Commands
IPv6 Basic Addressing
IPv6 address types:
Unicast
IPv6 neighbor
discovery
IPv6 stateless
autoconfiguration
IPv6 MTU path
discovery
IPv6 ICMPv6
IPv6 ping
IPv6 traceroute
IPv6 Routing
Static routing
544
| IPv6 Routing
lists the FTOS Version in which an IPv6 feature became available for each platform. The
FTOS Release Introduction
E-Series E-Series
TeraScale ExaScale C-Series S-Series S4810
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.4.1 8.2.1
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
7.8.1 7.8.1 8.3.10.0
c e s
Documentation and Chapter
Location
IPv6 Basic Commands in the
Command Line Interface Reference Guide
Extended Address Space
chapter
IPv6 Neighbor Discovery
chapter
Stateless Autoconfiguration
chapter
Path MTU Discovery
ICMPv6 in this chapter
ICMPv6 in this chapter
ICMPv6 in this chapter
Assign a Static IPv6 Route
chapter
FTOS
in this
in this
in this
in this chapter
in this