File Transfer Services; Configuration Task List For File Transfer Services - Dell Force10 S4810P Configuration Manual

To view the configuration, use the
To disable time stamping on syslog messages, enter

File Transfer Services

With FTOS, you can configure the system to transfer files over the network using File Transfer Protocol
(FTP). One FTP application is copying the system image files over an interface on to the system; however ,
FTP is not supported on VLAN interfaces.
For more information on FTP, refer to
Note: To transmit large files, Dell Force10 recommends configuring the switch as an FTP server.

Configuration Task List for File Transfer Services

The following list includes the configuration tasks for file transfer services:
• Enable FTP server
• Configure FTP server parameters
• Configure FTP client parameters
Enable FTP server
To enable the system as an FTP server, use the following command in the CONFIGURATION mode:
Command Syntax
ftp-server enable
To view FTP configuration, use the
shown in the example below.
FTOS#show running ftp
!
ftp-server enable
ftp-server username nairobi password 0 zanzibar
FTOS#
Configure FTP server parameters
After the FTP server is enabled on the system, you can configure different parameters.
show running-config logging
RFC 959, File Transfer Protocol.
(mandatory)
(optional)
(optional)
Command Mode
CONFIGURATION
show running-config ftp
command in the EXEC privilege mode.
no service timestamps [log | debug]
Purpose
Enable FTP on the system.
command in the EXEC privilege mode as
.
Management | 63