Dell Force10 S4810P Configuration Manual page 987

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Figure 47-9. Adding an S4810 Stack Unit with a Conflicting Stack Number—After

FTOS#show system brief

Stack MAC : 00:01:e8:8a:df:e6

Reload Type : normal-reload

---------------------------------------------------------------------------

Add a Configured Unit to an Existing Stack

To add a configured unit to an existing stack use the following steps.

If a stack unit goes down and is removed from the stack, the logical provisioning configured for that

stack-unit number is saved on the master and standby units. When a new unit is added to the stack, if a

stack group configuration conflict occurs between the new unit and the provisioned stack unit, the

configuration of the new unit takes precedence.

Add the configured unit to the top or bottom of the stack.

Power on the switch.

Attach cables to connect ports on the added switch to one or more existing switches in the stack.

Logon to the CLI and enter global configuration

Command Syntax

Password: *****

FTOS> enable

FTOS# configure

Command Mode

Stacking | 987

Troubleshooting