File System Management - Dell Force10 S4810P Configuration Manual

View Configuration Files
Configuration files have three commented lines at the beginning of the file, as shown in the example
below, to help you track the last time any user made a change to the file, which user made the changes, and
when the file was last saved to the startup-configuration.
In the running-configuration file, if there is a difference between the timestamp on the "Last configuration
change," and "Startup-config last updated," then you have made changes that have not been saved and will
not be preserved upon a system reboot.
FTOS#show running-config
Current Configuration ...
! Version 8.2.1.0
! Last configuration change at Thu Apr 3 23:06:28 2008 by admin
! Startup-config last updated at Thu Apr 3 23:06:55 2008 by admin
!
boot system rpm0 primary flash://FTOS-EF-8.2.1.0.bin
boot system rpm0 secondary flash://FTOS-EF-7.8.1.0.bin
boot system rpm0 default flash://FTOS-EF-7.7.1.1.bin
boot system rpm1 primary flash://FTOS-EF-7.8.1.0.bin
boot system gateway 10.10.10.100
--More--

File System Management

The Dell Force10 system can use the internal Flash, external Flash, or remote devices to store files. It
stores files on the internal Flash by default but can be configured to store files elsewhere.
To view file system information:
Task
View information about each file system.
The output of the command
free memory, file structure, media type, read/write privileges for each storage device in use.
FTOS#show file-systems
Size(b) Free(b)
520962048 213778432
127772672 21936128
-
-
-
You can change the default file system so that file management commands apply to a particular device or
memory.
Command Syntax
show file-systems
show file-systems
Feature Type Flags
dosFs2.0 USERFLASH
dosFs2.0 USERFLASH
- - network
- - network
- - network
in the example below shows the total capacity, amount of
Prefixes
rw flash:
rw slot0:
rw ftp:
rw tftp:
rw scp:
Command Mode
EXEC Privilege
Getting Started | 51