View Command History; Upgrading Ftos - Dell Force10 S4810P Configuration Manual

To change the default storage location:
Task
Change the default directory.
In the example below, the default storage location is changed to the external Flash of the primary RPM.
File management commands then apply to the external Flash rather than the internal Flash.
FTOS#cd slot0:
FTOS#copy running-config test
FTOS#copy run test
!
7419 bytes successfully copied
FTOS#dir
Directory of slot0:
1 drw- 32768
2 drwx
3 ----
4 -rw- 7419
5 ----
6 ----
7 ----
8 ----
9 ----
slot0: 127772672 bytes total (21927936 bytes free)

View command history

The command-history trace feature captures all commands entered by all users of the system with a time
stamp and writes these messages to a dedicated trace log buffer. The system generates a trace message for
each executed command. No password information is saved to the file.
To view the command-history trace, use the
below.
FTOS#show command-history
[12/5 10:57:8]: CMD-(CLI):service password-encryption
[12/5 10:57:12]: CMD-(CLI):hostname Force10
[12/5 10:57:12]: CMD-(CLI):ip telnet server enable
[12/5 10:57:12]: CMD-(CLI):line console 0
[12/5 10:57:12]: CMD-(CLI):line vty 0 9
[12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-CB-1.1.1.2E2.bin

Upgrading FTOS

Note: To upgrade FTOS, see the Release Notes for the version you want to load on the system.
52
| Getting Started
Jan 01 1980 00:00:00
512 Jul 23 2007 00:38:44
0 Jan 01 1970 00:00:00
Jul 23 2007 20:44:40
0 Jan 01 1970 00:00:00
0 Jan 01 1970 00:00:00
0 Jan 01 1970 00:00:00
0 Jan 01 1970 00:00:00
0 Jan 01 1970 00:00:00
Command Syntax
cd directory
.
..
DCIM
test
BT
200702~1VSN
G
F
F
show command-history
Command Mode
EXEC Privilege
command, as shown in the example