Wiring Plan, Single Chamber Housing - Siemens SITRANS LVL200S Operating Instructions Manual

SITRANS LVL200S l RELAY (DPDT)
1 Unscrew the housing cover
2 Loosen compression nut of the cable entry
3 Remove approx. 10 cm (4 in) of the cable mantle, strip
approx. 1 cm (0.4 in) insulation from the ends of the
individual wires
4 Insert the cable through the cable gland into the sensor
5 Open the terminals with a screwdriver
6 Insert the wire ends into the open terminals according to
the wiring plan
7 Tighten the terminals with a screwdriver
8 Check the hold of the wires in the terminals by lightly
pulling on them
9 Tighten the compression nut of the cable entry. The seal
ring must completely encircle the cable
10 Screw the housing cover on
The electrical connection is finished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the
EEx-d version.
Connecting to power supply
17