Table of Contents
Advertisement
8. Repeat for second strap by looping strap around pipe and feeding open end through strap
fastener and strap retainer. Pull loose end of strap tight to remove slack.
Note
Keep strap fastener in the center between the two strap retainers. See figure below.
Figure B-28
9. Take up the slack in the strap and position the strap retainer(s) at the selected plane(s);
either single or dual path.
10.Position the strap fastener away from the strap retainer for single path or at the best
location.
11.Bend the loose end of the strap to prevent it from loosening. Retrieve the strap fastener
set screw and install and tighten the set screw using the hex key.
12.Recheck alignment. Strap retainers should be aligned with each other and inline with the
pipe axis. The straps should now be mounted correctly for the selected path.
Mounting straps for Reflect mode - Dual enclosure
Note
Refer to Reflect mount overview figure as needed.
Follow the same mounting strap procedures used above for a Single enclosure housing but
add two more straps and two more strap retainers per strap.
B.4.3.2
Single enclosure - Reflect mount
Installation procedure
1. Place the enclosure housing over the strap retainers and slip into place. It may be
required to align or adjust the strap retainer studs to fit into their respective stand off
FSS200 clamp-on sensors
Installation Manual, 08/2017, A5E36255466-AC
Typical strap and strap retainer setup
Additional Installation Instructions
B.4 Hi Precision mount
117
Hide quick links:
Advertisement
Table of Contents
