Brocade Communications Systems StoreFabric SN6500B Reference page 914

5
ZONE-1002
ZONE Messages
ZONE-1002
Message
WWN zoneTypeCheck or zoneGroupCheck warning(<warning string>) at port(<port
number>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a failure
when creating or adding the zone groups during port login (PLOGI) trap processing. This message
usually indicates problems when adding the content-addressable memory (CAM) entries before the filter
setup.
Recommended
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
ZONE-1003
Message
zone(<current zone>) contains (<domain id>, <port number>) which does not exist.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the port zone member that is targeted for the local switch contains a nonexistent port. The
specified port number in the effective zoning configuration (displayed in the error message) is out of
range.
Recommended
Edit the zone database and change the port number to a viable value in the effective configuration.
Action
ZONE-1004
Message
Base PID: 0x<Base PID>, Port Index: <Port Index>, Port: <Slot/Port>: enforcement
changed to Session-based HARD Zoning.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the zoning enforcement has changed to session-based hard zoning due to one of the
following conditions:
•
•
892
The zone has a mix of WWN and domain,index (D,I) members.
The Source Identifier (S_ID) list of the hardware-enforced zoning exceeded the S_ID limit.
Fabric OS Message Reference
53-1002749-01