Brocade Communications Systems StoreFabric SN6500B Reference page 455

FSS-1004
Message
Memory shortage.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the system ran out of memory.
Recommended
Execute the memShow command to view memory usage in the switch.
Action
For a dual CP system, enable the high availability (HA) state synchronization using the haSyncStart
command. For non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSS-1005
Message
FSS read failure.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the read system call to the Fabric OS state synchronization (FSS) device has failed.
Recommended
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Action
FSS-1006
Message
No FSS message available.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that data is not available on the Fabric OS state synchronization (FSS) device.
Recommended
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
Fabric OS Message Reference
53-1002749-01
5
FSS-1004
433