Brocade Communications Systems StoreFabric SN6500B Reference page 694

5
RCS-1001
RCS Messages
RCS-1001
Message
RCS has been disabled. Some switches in the fabric do not support this feature.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the reliable commit service (RCS) feature has been disabled on the local switch because
not all switches in the fabric support RCS or the switch is in non-native mode.
Recommended
Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
Action v2.6, v3.1 and later, and v4.1 and later.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
RCS-1002
Message
RCS has been enabled.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the reliable commit service (RCS) feature has been enabled. RCS must be capable on all
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
Recommended
No action is required.
Action
RCS-1003
Message
Failed to allocate memory: (<function name>).
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified reliable commit service (RCS) function has failed to allocate memory.
Recommended
This message is usually transitory. Wait for few minutes and retry the command.
Action
Check memory usage on the switch using the memShow command.
Reboot or power cycle the switch.
672
Fabric OS Message Reference
53-1002749-01