Brocade Communications Systems StoreFabric SN6500B Reference page 372

5
FCR-1018
FCR-1018
Message
FC router proxy device entries exhausted on port <port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the number of proxy devices is greater than allowed by the port resource.
Recommended
Remove excess logical storage area network (LSAN) zones or devices until the number of proxy devices
Action exported is within the range allowed by the port resource. Use the fcrResourceShow command to view
resources including LSAN zone resources, LSAN device resources, and proxy device port resources.
Use the fcrProxyDevshow command to view how many proxy devices are created in the fabric with the
port resource problem. LSAN zones are removed using standard zoning commands such as zoneShow,
zoneRemove, zoneDelete, cfgDelete, and cfgDisable in the edge fabric. Proxy devices can be
removed by zoning operations or by bringing physical devices offline (for example, disabling the port that
a device is attached to, and then disconnecting the cable or disabling the device.
FCR-1019
Message
EX_Port or VEX_Port entries exhausted at port <port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the number of EX_Port or VEX_Port entries being created is greater than allowed by the
port resource.
Recommended
Disable EX_Ports or VEX_Ports until the number of ports is within the range allowed by the port
Action resource. The EX_Port or VEX_Port limit is displayed using the fcrRouteShow command. Use the
portDisable command to disable EX_Ports.
FCR-1020
Message
Local LSAN zone entries for FC router exhausted; max limit: <LSAN zone limit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the number of LSAN zones created within a MetaSAN exceeds the local LSAN zone
database limitations.
Recommended
Remove excess LSAN zones so that the number of LSAN zones created is within the range of the local
Action database limitations. To do that, perform the following steps:
1. Use the
2. Use the
350
command to disable all the EX_Ports that received this error message.
portDdisable
command to disable all the other EX_Ports on that FCR connected to the
portDdisable
same edge fabrics to which the EX_Ports disabled in step 1 are connected.
Fabric OS Message Reference
53-1002749-01