Brocade Communications Systems StoreFabric SN6500B Reference page 770

5
SEC-1327
SEC-1327
Message
Strict <Policy Name> policy WWN List is conflicting with domain <Domain Number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates the policy is conflicting with the domain.
Recommended
No action is required. The domain is denied by disallowing all its E_Ports connected to the fabric. If the
Action domain should be allowed to merge with the fabric, then resolve the issue by making the conflicting
policies the same.
SEC-1328
Message
Attempt to enable secure mode failed. Reason: <Reason>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the secModeEnable command failed on the fabric because the Authentication Policy is
enabled on the switch.
Recommended
Verify the security event was planned. If the security event was planned, run the authUtil --policy
Action passive command to disable the Authentication Policy and retry the secModeEnable command.
SEC-1329
Message
IPFilter enforcement:Failed to enforce ipfilter policy of <Policy Type> type
because of <Error code>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the IP filter policy enforcement failed because of an internal system failure.
Recommended
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
Action supportSave command and contact your switch service provider.
748
Fabric OS Message Reference
53-1002749-01