Brocade Communications Systems StoreFabric SN6500B Reference page 856

Brocade fabric os message reference v7.1.0 (53-1002749-01, march 2013)

Hide thumbs Also See for StoreFabric SN6500B:

Table of Contents

Run the firmwareDownloadStatus command for more information.

Refer to the Fabric OS Troubleshooting Guide for troubleshooting information.

Firmwaredownload failed in slot <Slot number>.

Message Type

Probable Cause

Indicates that the firmwareDownload command failed on the specified blade. The error may be caused

by the inconsistent application processor (AP) blade firmware stored on the active CP. It may also be

caused by an internal Ethernet issue or by a persistent storage hardware failure.

Run the slotShow command. If the blade is in the FAULTY state, run the slotPowerOff and

slotPowerOn commands to trigger another firmware download. If the blade is stuck in the LOADING

state, remove and re-insert the blade to trigger another firmware download. If the problem persists,

contact your switch service provider.

Firmwaredownload timed out in slot <Slot number>.

Message Type

Probable Cause

Indicates that there may be error caused by the blade initialization issue after the new firmware is

downloaded and the blade is rebooted. The error may also be caused by an internal Ethernet issue or by

a persistent storage hardware failure.

Run the slotShow command. If the blade is in the FAULTY state, run the slotPowerOff and

slotPowerOn commands to trigger another firmware download to the blade. If the blade is stuck in the

LOADING state, remove and re-insert the blade to trigger another firmware download. If the problem

persists, contact your switch service provider.

Fabric OS Message Reference

53-1002749-01

Fabric os v7.1.0