Brocade Communications Systems StoreFabric SN6500B Reference page 747

SEC-1157
Message
PID Change failed: <Reason> <defined status> <active status>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the provisioning resources for a security policy failed because of low memory or internal error.
The status values can be defined, active, or both. A negative value means that a policy set was failed by
the daemon.
Recommended
Retry the failed command.
Action
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
SEC-1158
Message
Invalid name <Policy or Switch name>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the specified name is invalid. The name can be a policy name or a switch name.
Recommended
Enter a valid name.
Action
SEC-1159
Message
Non_Reachable domain <Domain ID>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
Action the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
Fabric OS Message Reference
53-1002749-01
5
SEC-1157
725