Brocade Communications Systems StoreFabric SN6500B Reference page 157

AG-1042
Message
Sending ELS_PORT_OPEN failed on N_Port <port number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates there was a failure sending an ELS_PORT_OPEN request from the Access Gateway to the
fabric switch.
Recommended
Check the configuration of the fabric switch connected to the Access Gateway.
Action
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AG-1043
Message
Authentication cannot be negotiated with the connected switch/HBA and therefore
disabling the Port <port number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that authentication has failed on the specified port. A possible reason could be that the edge
switch connected to Access Gateway is using firmware earlier than Fabric OS v7.1.0.
Recommended
Check the authentication configuration of the edge switch using the authutil --show command.
Action
AG-1044
Message
Port <Port Number> has been disabled because switch requires authentication when
device authentication policy is set to ON.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates a device that does not support authentication has tried to log in to the switch when the device
authentication policy is in ON status on the switch.
Recommended
Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on the
Action switch if it is not mandatory. Use the authUtil command to change the device authentication policy.
Fabric OS Message Reference
53-1002749-01
5
AG-1042
135