Displaying Message Content On Switch - Brocade Communications Systems StoreFabric SN6500B Reference

1

Displaying message content on switch

TABLE 3
Command
portLogResize
portLogShow
portLogShowPort
portLogTypeDisable
portLogTypeEnable
rasAdmin
rasMan
setVerbose
snmpConfig
supportFfdc
supportFtp
supportSave
supportShow
syslogdFacility
syslogdIpAdd
syslogdIpRemove
syslogdIpShow
traceDump

Displaying message content on switch

Beginning with Fabric OS v7.1.0, you can view the message documentation such as the message
text, message type, class (for audit messages), message severity, cause, and action on the switch
console by using the rasMan message_ID command.
To display the message documentation on switch, perform the following steps.
1. Log in to the switch as admin.
2. Use the rasMan message_ID command to display the documentation of a message. The
14
Commands for viewing or configuring the system parameters and message logs (Continued)
Description
Resizes the port log to the specified number of entries.
Displays the port log, with page breaks.
Displays the port log of the specified port, with page breaks.
Disables an event from reporting to the port log. Port log events are described by the
portLogEventShow command.
Enables an event to report to the port log. Port log events are described by the
portLogEventShow command.
Used to enable or disable logging for selected messages or modules, to change the
default severity level for a specified message, and to display configured RASLog
message settings.
Displays message documentation on switch.
Sets the verbose level of a particular module within the Fabric OS.
Manages the SNMP agent configuration.
Enables and disables FFDC.
Sets, clears, or displays support FTP parameters or a time interval to check the FTP
server.
Collects RASLog, trace files, and supportShow (active CP only) information for the local
CP and then transfers the files to an FTP server. The operation can take several
minutes.
Executes a list of diagnostic and error display commands. This output is used by your
switch service provider to diagnose and correct problems with the switch. The output
from this command is very long.
Changes the syslogd facility.
Adds an IP address as a recipient of system messages.
Removes an IP address as a recipient of system messages.
Views the currently configured IP addresses that are recipients of system messages.
Displays, initiates, or removes a Fabric OS module trace dump.
message_ID values are case-sensitive.
Fabric OS Message Reference
53-1002749-01