Brocade Communications Systems StoreFabric SN6500B Reference page 859

Brocade fabric os message reference v7.1.0 (53-1002749-01, march 2013)

Hide thumbs Also See for StoreFabric SN6500B:

Table of Contents

Wait for the blade to reboot.

Firmware commit operation started on the blade in slot <Slot number>.

Message Type

Probable Cause

Indicates that the firmwareCommit command has started on the specified blade. The operation may be

a normal part of firmware download, or it may have started to repair the secondary partition of the blade if

the secondary partition is corrupted.

Wait for the firmware commit operation to complete.

The switch has rebooted during relocating the internal firmware image.

Message Type

Probable Cause

Indicates that there may be an error caused by an unexpected disruption of the firmwareDownload

command; for example, by powering the switch off and on in the middle of a firmware download. The

error may also be caused by persistent storage hardware failure or by a software error.

The firmwareDownload command will continue after the switch has rebooted. Run the

firmwareDownloadStatus command to monitor progress. If the problem persists, contact your switch

service provider.

The switch is relocating an internal firmware image.

Message Type

Probable Cause

Indicates that the switch has rebooted with the new firmware and is relocating the application processor

(AP) firmware.

Fabric OS Message Reference

53-1002749-01

Need help?

Do you have a question about the StoreFabric SN6500B and is the answer not in the manual?

Fabric os v7.1.0