Brocade Communications Systems StoreFabric SN6500B Reference page 454

Brocade fabric os message reference v7.1.0 (53-1002749-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

5
FSS-1001
FSS Messages
FSS-1001
Message
Component (<component name>) dropping HA data update (<update ID>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an application has dropped a high availability (HA) data update.
Recommended
For a dual control processor (CP) system, enable the HA state synchronization using the haSyncStart
Action
command. For non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSS-1002
Message
Component (<component name>) sending too many concurrent HA data update
transactions (<dropped update transaction ID>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an application has sent too many concurrent high availability (HA) data updates.
Recommended
For a dual CP system, enable the HA state synchronization using the haSyncStart command. For
Action
non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSS-1003
Message
Component (<component name>) misused the update transaction (<transaction ID>)
without marking the transaction begining.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Fabric OS state synchronization (FSS) service has dropped the update because an
application did not set the transaction flag correctly.
Recommended
For a dual CP system, enable the high availability (HA) state synchronization using the haSyncStart
Action
command. For non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
432
Fabric OS Message Reference
53-1002749-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.1.0

Table of Contents