Brocade Communications Systems StoreFabric SN6500B Reference page 316

5
EM-1067
EM-1067
Message
Stopping synchronization of the system due to <version> incompatibility with
standby CP.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the software version on the standby control processor (CP) is incompatible with this
software feature enabled on this Fabric OS firmware version.
Recommended
Upgrade the software on the standby CP or disable the software feature on this CP.
Action
To disable the Ethernet switch service, execute the fosconfig --disable ethsw command.
To view the buffer optimization mode for the slots, execute the bufopmod --showall command, and then
execute the bufopmode --reset slot command to disable the feature for those slots before downgrading.
To disable FC8-16 Serdes tuning mode, execute the serdestunemode --reset command.
EM-1068
Message
High Availability Service Management subsystem failed to respond. A required
component is not operating.
Message Type
FFDC | LOG
Severity
ERROR
Probable Cause
Indicates that the high availability (HA) subsystem has not returned a response within four minutes of the
request from the environmental monitor (EM). It usually indicates that some component has not started
properly or has terminated. The specific component that has failed may be indicated in other messages
or debug data. There are serious internal Fabric OS configuration or hardware problems on the switch.
Recommended
Restart or power cycle the switch.
Action
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
EM-1069
Message
Slot <FRU slot number> is being powered off.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the blade in the specified slot is being intentionally powered off.
Recommended
No action is required.
Action
294
Fabric OS Message Reference
53-1002749-01