Brocade Communications Systems StoreFabric SN6500B Reference page 330

Brocade fabric os message reference v7.1.0 (53-1002749-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

5
FABR-1012
FABR-1012
Message
<function stream>: no such type, <invalid type>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the fabric is not in the appropriate state for the specified process. This message is rare and
usually indicates a problem with the Fabric OS.
Recommended
The fabric daemon will take proper action to recover from the error.
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1013
Message
No Memory: pid=<fabric process id> file=<source file name> line=<line number
within the source file>.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is
rare and usually indicates a problem with the Fabric OS.
Recommended
The system will recover by failing over to the standby CP.
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1014
Message
Port <port number> Disabled: Insistent Domain ID <Domain ID> could not be
obtained. Principal Assigned Domain ID = <Domain ID>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified port received a request domain ID (RDI) accept message containing a
principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). Fibre
connectivity (FICON) mode requires an insistent domain ID. If an RDI response has a different domain
ID, then the port is disabled.
Recommended
Run the configShow command to view the fabric.ididmode. A 0 means the IDID mode is disabled; a 1
Action
means it is enabled.
Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web
Tools on the Switch Admin > Configure window.
308
Fabric OS Message Reference
53-1002749-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.1.0

Table of Contents