Brocade Communications Systems StoreFabric SN6500B Reference page 313

EM-1058
Message
Switch gets reset:<Fault reason>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch is being automatically reset because of a known resetable transient problem
such as an application-specific integrated circuit (ASIC) parity error.
Recommended
No action is required if the switch does not reach the reset threshold for the switch or blade. If the reset
Action threshold is reached on the switch or blade, the switch or blade will be faulted and should be replaced.
EM-1059
Message
<Slot number or Switch> with ID <Blade Id> may not be supported on this platform,
check FOS firmware version as a possible cause.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that a a blade inserted in the specified slot or the switch (for non-bladed switches) is
incompatible with the switch configuration software. The blade will not be completely usable.
The blade may only be supported by a later (or earlier) version of the firmware.
Recommended
Change the control processor (CP) firmware or replace the blade. Make sure the replacement is
Action compatible with your switch type and firmware.
EM-1060
Message
Stopping synchronization of the system due to blade incompatibility with software
version on standby CP.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a blade in the system is not supported by the firmware on the standby control processor
(CP).
Recommended
Remove all blades of this type or upgrade the standby CP. After an appropriate action is taken, restart the
Action standby CP or execute the haSyncStart command to enable the high availability (HA) state
synchronization. Until this is done, the system will remain out of synchronization.
Fabric OS Message Reference
53-1002749-01
5
EM-1058
291