Brocade Communications Systems StoreFabric SN6500B Reference page 143

Fabric OS System Messages
AG Messages
AG-1001
Message
N_Port ID virtualization (NPIV) is not supported by fabric port connected to port
<port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the N_Port ID virtualization (NPIV) capability is not supported by the fabric port to which
the Access Gateway is connected.
•
Recommended
Action
•
•
AG-1002
Message
Unable to find alternate N_Port during failover for N_Port <port number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that no other N_Port is configured or the fabric was unstable during failover.
Recommended
Check whether an alternate N_Port is configured using the portCfgShow command.
Action
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Fabric OS Message Reference
53-1002749-01
Execute the
portCfgNpivPort
Access Gateway.
Some blades and ports in a switch may not support NPIV. NPIV functionality cannot be enabled
on such ports and they will not respond to NPIV requests. Refer to the
for specific AG-compatibility requirements.
Administrator's Guide
On non-Brocade switches, refer to the manufacturer's documentation to determine whether
the switch supports NPIV and how to enable NPIV on these types of switches.
command to enable NPIV capability on the port connected to the
Chapter
5
Access Gateway
121