HP StorageWorks 2/64 - Core Switch Command Reference Manual page 692

Port State
comment
692 Fabric OS commands
Port state information
No_Card No interface card present.
No_Module No module (SFP or other) present.
Mod_Val Module validation in process.Mod_Inv – nvalid module.
No_Light Module not receiving light.
No_Sync Module receiving light but out of sync.
In_Sync Module receiving light and in sync.
Laser_Flt Module signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
Testing Running diagnostics.
Online Port is up and running.
The comment field is blank, or displays:
Disabled Port is disabled.
Bypassed Port is bypassed (loop only).
Loopback Port is in loopback mode.
E_Port Fabric port; displays WWN and name of attached
switch.
F_Port Point-to-point port; displays WWN of attached N_Port.
G_Port Point-to-point but not yet E_Port or F_Port.
L_Port Loop port; displays number of NL_Ports.
(Trunk master) Port is the master port in a group of trunking ports.
(Trunk port, master is port #x) – Port is configured as a
trunking port; the master port is port number x.
(upstream)
E_Port is an upstream path towards the principal switch
of the fabric.
(downstream)
E_Port is a downstream path away from the principal
switch of the fabric.
Persistently Disabled
This port has been disabled using
portCfgPersistentDisable.
FICON – Persistent DID
This port has been disabled since the switch could not
obtain its configuration domain ID during the fabric
reconfiguration when FICON mode was enabled. See
ficonShow
If a port is configured as a long distance port, the long
distance level is displayed in the format of Lx, which
represents the long distance level number. See
portCfgLongDistance
for more information.
for more information