Ficoncupset - HP StorageWorks 2/64 - Core Switch Command Reference Manual

ficoncupset

Sets FICON-CUP parameters for a switch.
Synopsis
ficoncupset fmsmode enable | disable
ficoncupset modereg bitname 0 | 1
Availability
admin
Description
Use this command to set FICON-CUP (Control Unit Port) parameters for a switch. All the parameters
described below can be set while the switch is online. Changes to parameters are effective immediately. A
reboot is not required for the changes to take effect.
Operands
The following operands are supported:
fmsmode
modereg
Examples
To enable FMS mode for the switch:
switch:admin> ficoncupset fmsmode enable
fmsmode for the switch is now Enabled
To set ASM bit in the mode register for the switch:
switch:admin> ficoncupset modereg ASM 1
Active=Saved Mode bit is set to 1
See Also
ficoncupshow
Enable or disable the FICON Management Server (FMS) mode for the
switch. When parameter is fmsmode, argument is either enable or
disable.
Set a bit in the FICON-CUP mode register. When parameter is modereg,
one of the following bitname operands should be specified, followed by 0
or 1:
Programmed offline state control
POSC
User alert mode
UAM
Active=saved mode
ASM
Director clock alert mode
DCAM
Alternate control prohibited
ACP
Host control prohibited
HCP
Fabric OS 5.x command reference guide 225