Trunkdebug - HP StorageWorks 2/64 - Core Switch Command Reference Manual

trunkDebug

Debugs a trunk link failure.
Synopsis
trunkdebug port1 port2
Availability
admin
Description
Use this command to debug a trunk link failure. This command reports one of the following messages,
based on the trunking properties of the two specified ports:
•
Switch does not support trunking
•
Trunking license required
•
Trunking not supported in switch interop mode
•
port port_id is not E_Port
•
port port_id trunking disabled
•
port port_id speed is not 2G or 4G
•
port port_id and port port_id are not on same port group
•
port port_id and port port_id connect to different switches
•
port port_id is not a trunking port due to: E_Port being disabled, or
trunking might be disabled at remote port
•
port port_id and port port_id cannot trunk, please check link length to
make sure difference is less than 400m
Operands
This command has the following operands:
port1
port2
Examples
To debug a trunk connection:
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together
724 Fabric OS commands
Specify the area number of port 1. Use the
the area numbers for a port. This operand is required.
Specify the area number of port 2. Use the
the area numbers for a port. This operand is required.
command to view
switchShow
command to view
switchShow