Portswap - HP StorageWorks 2/64 - Core Switch Command Reference Manual

portSwap

Swaps area numbers of two ports.
Synopsis
portswap [slotnumber1/]portnumber1 [slotnumber2/]portnumber2
Availability
admin
Description
Use this command to swap area numbers for a pair of ports. Both ports must be disabled prior to
executing this command and the port-swapping feature must be enabled using portSwapEnable.
NOTE: To undo a previous port swap, execute
information is kept in its own database; it cannot be manipulated by editing the configuration
portSwap
database displayed by
Operands
This command has the following operands:
slotnumber1
portnumber1
slotnumber2
portnumber2
Examples
To swaps area numbers between a pair of ports:
switch:admin> portswap 1/e 2/5
portswap done
and configUpload.
configShow
For bladed systems only, specify the slot number of the first port whose
area number is to be swapped, followed by a slash (/).
Specify a port number to be configured, relative to its slot for bladed
systems. Use
switchShow
For bladed systems only, specify the slot number of the second port
whose area number is to be swapped, followed by a slash (/).
Specify a port number to be configured, relative to its slot for bladed
systems.
again on the same two ports.
portSwap
to display a list of valid ports.
Fabric OS 5.x command reference guide 521