HP StorageWorks 2/64 - Core Switch Command Reference Manual page 134

-spd_mode mode
Examples
To run a functional test of all the ports on a switch:
switch:admin> crossporttest -ports 1/0-1/15
Running crossporttest ..............
Ports Segmented (0)
Executing test ...
Test Complete: "crossporttest" Pass 10 of 10
Duration 0 hr, 0 min & 8 sec (0:0:8:725).
passed.
See also
camTest
centralMemoryTest
134 Fabric OS commands
Specify the speed mode for the test. This parameter is used only for Bloom and
Condor ASIC-based products, for which it controls the speed at which each port
is operated. For 1 Gb/s-only products it is ignored. The exact operation of each
mode 5 through 8 depends upon the loopback mode selected. When speed
modes 5 through 8 are used with cables, they must be connected even to odd or
the test will fail. Valid values are:
Run test at both 1 Gb/s, 2 Gb/s, and 4 Gb/s (default)
0
Set all port speeds to 1 Gb/s
1
Set all port speeds to 2 Gb/s
2
Set all port speeds to 4 Gb/s
4
For -lb_mode set to 0 or 1, the following speed modes are available to test the
speed negotiation:
Set all even ports speed to AN; set all odd ports speed to 1
3
Gb/s.
Set all even ports speed to AN; set all odd ports speed to 2
4
Gb/s.
Set all odd ports speed to AN; set all even ports speed to 1
5
Gb/s.
Set all odd ports speed to AN; set all even ports speed to 2
6
Gb/s.
For -lb_mode set to 2,3, the following speed modes are available to test FIFO
underrun:
Set all even ports speed to 2 Gb/s; set all odd ports speed to
3,5
1 Gb/s.
Set all even ports speed to 1 Gb/s; set all odd ports speed to
4,6
2 Gb/s.
Specify 1 to force the test to skip part of the POST cleanup
-norestore
normally performed. This might be helpful during debug. This
mode
parameter should normally be left at the default value of 0.
Specify a list of user ports to test. By default, all the user ports
-ports
in the current switch will be used. See
itemlist
information.
for more
itemList