Agtcfgdefault - HP StorageWorks 2/64 - Core Switch Command Reference Manual

agtCfgDefault

Resets the SNMP agent configuration to default values.
Synopsis
agtcfgdefault
Availability
admin
Description
Use this command to reset the SNMP agent configuration with the switch default values.
This command prompts the user and proceeds to reset only on the user's confirmation. All new values
successfully configured by the command take effect immediately. These changes are persistent across
power cycles and reboots. For dual-domain systems, agtCfgDefault operates on the SNMP agent
associated with the current switch.
This command resets the following values (See the HP StorageWorks Fabric OS 5.x MIB reference guide
for detailed sysDescr, sysLocation, and sysContact descriptions):
sysDescr
sysLocation
sysContact
authTraps
There are six communities and respective trap recipients supported by the agent. The first three
communities are for read-write (rw) access and the last three are for read-only (ro) access. The default
value for the trap recipient of each community is 0.0.0.0. The default values for the community strings are
as follows:
• Community 1: Secret Code
• Community 2: OrigEquipMfr
• Community 3: private
• Community 4: public
• Community 5: common
• Community 6: FibreChannel
For an SNMP management station to receive a trap generated by the agent, the administrator must
configure a trap recipient to correspond to the IP address of the management station. In addition, the trap
recipient must be able to pass the access control list (ACL) check.
Trap recipient severity level
The trap severity level is associated with each trap recipient IP address. The event trap level is in
conjunction with the event's severity level. When an event occurs and if its severity level is at or below the
set value, the SNMP event traps (swEventTrap, swFabricWatchTrap, and connUnitEventTrap)
The system (switch) description. The default value is Fibre Channel Switch in most
platforms; however, the default system description value is platform-specific.
Different values might appear as the default for some specialized platforms.
The location of the system. The default value is End User Premise.
The contact information for the system. The default value is Field Support.
When enabled, the authentication trap, authenticationFailure, is transmitted to a
configured trap recipient in the event the agent received a protocol message that
is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this
means that a request contains a community string that is not known to the agent.
The default value for this parameter is 0 (disabled).
Fabric OS 5.x command reference guide 25