HP StorageWorks 2/64 - Core Switch Command Reference Manual page 493

ctin
ctout
errlog Error type (see errModuleShow)
loopscn The meaning further depends on each loop state:
OLP
LIP
LIM
BMP
OLD
TMO
Codes used in various fields are as follows:
state 1
2
3
4
5
6
7
pstate AC
LR1
LR2
LR3
Argument 0 is divided into two 16-bit fields:
[A] A bit map indicating whether subsequent args
are valid (0001 means argument 1 is valid,
0003 means arguments 1 and 2 are valid)
Argument 1 is the first word of the CT payload, if
applicable (as specified in [A])
Argument 2 is the second word of the CT
payload, if applicable (as specified in [A]).
[B] The CT-based service command code
Argument 0 is also divided into two 16-bit fields:
[A] A bit map indicating whether subsequent args
are valid (0001 means argument 1 is valid,
0003 means arguments 1 and 2 are valid).
[B] The CT command code indicating whether an
accept (8002) or a reject (8001).
If [B] is an accept, argument 1 and 2 represents
the first and second words of the CT payload, if
applicable (as specified in [A]).
If [B] is a reject, argument 1 contains the CT
reject reason and explanation code.
Offline reason code, usually zero
Reason code for LIPs initiated by FL_Port, if the code value is
800x (x = [1,0xc], see below), or the lower two bytes of the
LIP received, if the code value is other than 800x
Usually zero
Memory address for the loop bitmap
Usually zero
Encoded value of the state when loop init timed out This
value is usually equal to the first word of a loop init frame
payload. Other possible values include:
2 LIP (req. INITIALIZING) timeout
94F0F0 ARB(F0) timeout
40 CLS timeout
Online
Offline
Testing
Faulty
E_Port
F_Port
Segmented
Active State
Link Reset: LR Transmit State
Link Reset: LR Receive State
Link Reset: LRR Receive State
Fabric OS 5.x command reference guide 493