HP StorageWorks 2/64 - Core Switch Command Reference Manual page 33

Trap recipient severity level
The event trap level in conjunction with the event's severity level. When an event occurs and if its severity
level is at or below the set value, the SNMP trap, swEventTrap, is sent to configured trap recipients. By
default, this value is set to 0, implying that no swEventTrap is sent. Possible values are:
0
1
2
3
4
5
See
errShow
The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts under a
host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL of
192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is
enabled to set each host-subnet-area to be read-write or read-only. The highest privilege matched out of
six entries is given to the access. The ACL check is turned off when all six entries contain 0.0.0.0.
NOTE: When secure mode is enabled, the access control list feature is incorporated into the WSNMP
and RSNMP security policies. Community strings can be changed on the primary FCS switch only and
will propagate changes across the fabric.
Operands
none
Examples
switch:admin> agtcfgshow
Current SNMP Agent Configuration
SNMPv1 community and trap recipient configuration:
(continued on next page)
none
critical
error
warning
informational
debug
for related information.
Customizable MIB-II system variables:
sysDescr = FC Switch
sysLocation = End User Premise
sysContact = Field Support.
authTraps = 1 (ON)
Community 1: Secret C0de (rw)
Trap recipient: 192.168.1.51
Trap recipient Severity level: 4
Community 2: OrigEquipMfr (rw)
Trap recipient: 192.168.1.26
Trap recipient Severity level: 0
Community 3: private (rw)
No trap recipient configured yet
Fabric OS 5.x command reference guide 33