Diagshowtime - HP StorageWorks 2/64 - Core Switch Command Reference Manual
Hp storageworks fabric os 5.x command reference guide (aa-rvhvb-te, september 2005)
Hide thumbs
Also See for StorageWorks 2/64 - Core Switch:
- Reference manual (278 pages) ,
- Installation manual (166 pages) ,
- Administrator's manual (152 pages)
Table of Contents
Advertisement
diagShowTime
Sets or displays diagnostic show-time mode.
Synopsis
diagshowtime [mode | -show]
Availability
admin
Description
Use this command to enable show-time mode (if the mode value is not 0) or disable the show-time mode
(if the mode value is set to 0). The mode is saved in flash memory (and stays in that mode) until the next
execution of diagShowTime. The mode becomes active as soon as this command is executed; it does
not require a reboot to take effect.
Show-time mode, when enabled, causes each test to display elapsed-time messages. It is normally used
during burn-in and for test method debugging.
NOTE:
diagsetshowtime is an alias of diagshowtime.
Operands
This command has the following optional operands:
mode
-show
If no operand is specified, the current value is displayed.
Examples
To enable show-time mode:
switch:admin> diagshowtime
Show Time mode is 0 (Disabled).
switch:admin> diagshowtime 1
Config update Succeeded
Show Time mode is now 1 (Enabled).
158 Fabric OS commands
Specify 1 (or any nonzero value) to enable show-time mode;
specify 0 to disable show-time mode.
Specify this operand to display the current mode setting.
Advertisement
Table of Contents
