HP StorageWorks 2/64 - Core Switch Command Reference Manual page 50
Hp storageworks fabric os 5.x command reference guide (aa-rvhvb-te, september 2005)
Hide thumbs
Also See for StorageWorks 2/64 - Core Switch:
- Reference manual (278 pages) ,
- Installation manual (166 pages) ,
- Administrator's manual (152 pages)
Table of Contents
Advertisement
Examples
To display the current policy and then change it from an exchange-based to a device-based policy:
switch:admin> aptpolicy
Current Policy: 3
3: Default Policy
1: Port Based Routing Policy
2: Device Based Routing Policy
3: Exchange Based Routing Policy
switch:admin> aptpolicy 2
Switch must be disabled in order to modify this configuration
parameter. To disable the switch, use the "switchDisable" command.
switch:admin> switchdisable
switch:admin> aptpolicy 2
Policy updated successfully.
switch:admin> switchenable
switch:admin> aptpolicy
Current Policy: 2
3: Default Policy
1: Port Based Routing Policy
2: Device Based Routing Policy
3: Exchange Based Routing Policy
50
Fabric OS commands
•
Exchange-based routing policy
With this policy, the path chosen for an ingress frame is based on:
Ingress port on which the frame was received
• FC address of the SID for this frame
• FC address of the DID for this frame
• FC Originator Exchange ID (OXID) for this frame
This policy allows for optimal utilization of the available paths as I/O traffic
between different (SID, DID, OXID) pairs can use different paths. All frames
received on a ingress port with the same (SID, DID, OXID) parameters takes the
same path unless there is a fabric event. See
fabric event.
This policy does not support static routes. DLS always is enabled and the DLS
setting cannot change with this policy.
for the definition of a
dlsSet
Advertisement
Table of Contents
