HP StorageWorks P9000 Manual page 319

Table 93 Error codes (part code 20123) (continued)
Part Error Error Message
Code Number
20123 107016 A network error occurred. It is not
possible to connect with the SVP due to
one of the following reasons.
The SVP was not ready.
An error occurred in the SVP.
20123 107017 An error occurred during SVP
processing.
20123 107018 A network error occurred. It is not
possible to connect with the SVP because
a timeout error occurred while
communicating with the SVP.
20123 107019 Failed to restore the user account list file.
20123 107020 An unsupported version of JRE is used.
20123 107021 An internal logic error occurred.
20123 107022 An internal logic error occurred.
20123 107023 An internal logic error occurred.
20123 107024 The content of a task to be registered
conflicts with that of another that has
already been registered. Retry the
operation.
20123 107025 The operation failed, because the
configuration information was being
changed.
20123 107026 The operation failed because the storage
system performed refreshing internally.
20123 107027 The refreshing operation was not
completed because the configuration
was changing.
Recommended Action
Check the internet protocol (IP) address.
If the IP address is correct, terminate the
browser (also terminate the storage list
browser), then log it in again.
If this problem persists, please contact
HP Technical Support.
Log in again.
If this problem persists, please contact
HP Technical Support.
Install a supported version of JRE, then
retry the operation.
Refresh the window, then retry the
operation. If the same problem persists
despite retrying, please contact HP
Technical Support.
Refresh the window, then retry the
operation. If the same problem persists
despite retrying, please contact HP
Technical Support.
Click [Refresh All] on the [File] menu,
then retry the operation. If the same
problem persists despite retrying, please
contact HP Technical Support.
If the same problem persists despite
retrying, please contact HP Technical
Support.
Wait for a while, then retry the
operation.
Wait, then retry the refreshing operation.
Wait, then retry the refreshing operation.
Severity
Level
E
E
E
E
W
E
E
E
E
W
W
W
Part code 20123 319