HP StorageWorks P9000 Manual page 300

Table 83 Error codes (part code 9205) (continued)
Part Error
Code Number
9205 6023
9205 6038
9205 6502
9205 6533
9205 6537
9205 7060
9205 71 1 1
9205 7310
9205 8001
9205 8002
9205 8102
9205 8120
9205 8121
9205 8122
9205 8126
9205 8136
9205 8140
9205 8141
9205 8142
9205 56524
300 Message (part code group 9nnn)
Error Message
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
The mistake is found in the set
parameter.
Processing in progress. Please wait for
a while, and then retry the operation.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
The setting process has not been
executed because there is no error in this
setting, but an error in the other settings.
An error occurred during SVP
processing.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
This error code is not registered.
An error occurred while connecting to
the subsystem. Please retry a little later.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
This function is not supported.
The specified logical volume does not
exist.
This logical volume is an open volume.
This logical volume is busy.
The logical volume is configured as a
command device.
The command was rejected, because the
licensed capacity was exceeded.
This logical volume cannot be selected
because it is used as a volume for
Compatible FlashCopy.
This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
You cannot select this logical volume
because it is used as a Continuous
Access Journal Z volume.
This function cannot be used by the
storage partition administrator.
Recommended Action
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Wait a few minutes, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
Check the error factor in the other
settings.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Retry a little later.
Retry a little later.
Check if the DKCMAIN and SVP
microcode versions are mismatched.
Specify a mainframe Volume.
Specify a mainframe Volume.
Retry a little later.
Check the logical volume configuration,
then retry the operation.
The currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
Confirm, and operate the volume again.
Check the volume, then retry the
operation.
Check the logical volume, then retry the
operation.
If the problem persists despite retrying,
please contact HP Technical Support.
Severity
Level
E
E
W
E
W
E
E
E
W
W
W
W
W
W
W
W
W
W
W
E