HP StorageWorks P9000 Manual page 296

Table 80 Error codes (part code 9105) (continued)
Part Error
Code Number
9105 5608
9105 5609
9105 5819
9105 5820
9105 6012
9105 6023
9105 7060
9105 71 1 1
9105 7310
9105 8001
9105 8002
9105 8102
9105 81 10
9105 8659
9105 55548
9105 56524
9105 67000
9105 67001
296 Message (part code group 9nnn)
Error Message
The pool group cannot include volumes
to which LU paths are defined, or
volumes which are not mounted.
The R-VOL/T-VOL exists in a group which
cannot include R-VOLs and T-VOLs.
The specified port is not supported by
this function.
When the host group has a host to which
ports are set, the hosts in this host group
cannot be registered in another host
group.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
The file operation failed.
An error occurred during SVP
processing. If this problem persists please
contact HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
Unregistered error code.
A communication time-out error occurred.
Communication is busy. Please retry
later.
The SVP version and the DKC version do
not match.
The configuration could not be changed.
No PCBs are installed for mainframe
computers.
The specified LDEV is a journal volume,
and therefore cannot be registered in
LDEV groups.
This function cannot be used by the
storage partition administrator.
The LDKC Number is incorrect.
There are no LDKCs mounted.
Recommended Action
Click [OK], check the attributes of the
specified volumes, and retry the
operation.
Click [OK].
Change the group attribute or delete the
R-VOL/T-VOL from the group.
Retry the operation.
Specify a port supported by this function.
Check the specified host and port.
An error occurred during the SVP
processing. If this problem persists,
please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Retry the operation. If you get the same
message again, reboot the PC. If
necessary, please contact HP Technical
Support.
Wait a moment and retry.
Please contact HP Technical Support.
Please contact HP Technical Support.
Install PCBs for mainframe computers,
then retry the operation.
Please release the journal volume setting,
or delete the target volume from the LDEV
group.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
There are no volumes mounted. Install
additional volumes to execute the
operation.
Severity
Level
W
W
W
W
E
E
E
E
E
E
W
E
E
E
W
E
E
W