HP StorageWorks P9000 Manual page 286

Table 71 Error codes (part code 8505) (continued)
Part Error
Code Number
8505 55033
8505 55228
8505 56501
8505 56502
8505 56524
8505 56527
8505 56536
8505 57002
8505 58310
8505 5831 1
8505 58312
8505 58313
286 Message (part code group 8nnn)
Error Message
The same port is already registered in a
different SLPR.
This function is not available.
Open System Array Management is
required to create CLPR.
The login information of the partition
management function has been
initialized due to detection of conflicting
information. Please contact the storage
administrator. (To the storage
administrator: Please reconfigure the
login information.)
The operation to set the maximum
number of connections has been
cancelled because an attempt has been
made to specify this value to less than
the number of users who are currently
connected. Check the maximum
permissible number of connections.
This function cannot be used by the
storage partition administrator.
While another user is logged into
Remote Web Console, you cannot edit
the information of the SLPR that the user
owns. SLPR No:%s
The licensed capacity was exceeded
because of changing the configuration.
Please correct the licensed capacity on
the License Key Partition Definition panel.
The licensed capacity was exceeded
because the configuration is changed.
An unknown error was detected.
Some shared memory of the storage
system may be blocked, or the storage
system is being maintained.
Some cache memory of the storage
system may be blocked, or the storage
system is being maintained.
The configuration cannot be changed
because the write pending rate of the
intended CLPR is too high. Please wait
until the write pending rate falls, and
then retry the operation.
The configuration cannot be changed
because the available Cache Residency
size or the number of Cache Residency
areas in the intended CLPR is insufficient.
Recommended Action
Please contact HP Technical Support.
Install the program product.
Please contact the storage administrator.
(To the storage administrator:
Reconfigure the login information. If this
problem persists, please contact HP
Technical Support.)
The operation to set the maximum
number of connections has been
cancelled because an attempt was made
to specify a value that is less than the
number of users who are currently
connected. Check the maximum
permissible number of connections.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Correct the licensed capacity on the
License Key Partition Definition panel.
If this problem persists, please contact
HP Technical Support.
Check the status of the storage system.
If this problem persists, please contact
HP Technical Support.
Check the status of the storage system.
If this problem persists, please contact
HP Technical Support.
Wait until the write pending rate falls,
then retry the operation.
Check the Cache Residency size and the
number of Cache Residency areas.
Severity
Level
E
W
i
W
E
E
W
E
W
W
W
W