HP StorageWorks P9000 Manual page 259

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8618 The T-VOL is already defined as an
S-VOL.
7105 8619 The specified T-VOL is defined as a
source volume for Auto LUN.
7105 8622 The command has been rejected,
because the specified volume is used as
M-VOL of Continuous Access
Synchronous Z pair.
7105 8623 The command has been rejected,
because the specified volume is used as
R-VOL of Continuous Access Synchronous
Z pair.
7105 8624 The command has been rejected,
because there is no pair to be operated.
7105 8625 The P-VOL(S-VOL) and S-VOL(T-VOL)
have the same number.
7105 8626 The Simplex command was rejected,
because the high-speed Split was in
progress.
7105 8627 The Pairresync operation has been
rejected, because pair status is SP-Pend.
7105 8628 An internal logic contradiction occurred.
7105 8629 The status mode specification is invalid.
7105 8630 The status mode type is invalid.
7105 8631 The specified CU number is invalid.
7105 8632 The timing of issuing the command is
invalid.
7105 8633 The abnormal status is invalid.
7105 8634 The volume specified as a reserved
volume is already defined as a reserved
volume for Auto LUN.
7105 8635 The specified S-VOL is defined as a
reserved volume for Auto LUN.
7105 8636 The specified T-VOL is defined as a
reserved volume for Auto LUN.
7105 8637 The specified S-VOL is used as a source
volume for Auto LUN.
7105 8638 The command has been rejected
because the specified S-VOL is set for
use in Cache Residency Z.
7105 8639 The command has been rejected
because the specified T-VOL is set for
use in Cache Residency Z.
Recommended Action
Check the volume number.
Release the Auto LUN setting.
The P-VOL of Continuous Access
Synchronous Z pair cannot be used as
a reserved volume.
Specify another volume.
The R-VOL of Continuous Access
Synchronous Z pair cannot be used as
a reserved volume.
Specify another volume.
Confirm whether the volumes specified
for S-VOL and T-VOL are correct or not.
Check the specified volume number.
After the high-speed Split is completed,
retry the operation.
Wait until the status of the pair changes
to Split.
Select other pairs.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
You cannot execute the specified
operation. To execute it, release the
setting of Cache Residency Z.
You cannot execute the specified
operation. To execute it, release the
setting of Cache Residency Z.
Severity
Level
W
W
W
W
W
W
W
W
E
W
W
W
E
E
W
W
W
W
W
W
Part code 7105 259